Like most other operating systems, LFS is usually installed on a dedicated partition. The recommended approach to building an LFS system is to use an available empty partition or, if you have enough unpartitioned space, to create one.
A minimal system requires a partition of around 1.3 gigabytes (GB). This is enough to store all the source tarballs and compile the packages. However, if the LFS system is intended to be the primary Linux system, additional software will probably be installed which will require additional space (2-3 GB). The LFS system itself will not take up this much room. A large portion of this requirement is to provide sufficient free temporary storage. Compiling packages can require a lot of disk space which will be reclaimed after the package is installed.
Because there is not always enough Random Access Memory (RAM)
available for compilation processes, it is a good idea to use a small
disk partition as
swap space. This is
used by the kernel to store seldom-used data and leave more memory
available for active processes. The
swap partition for an LFS system can be the same
as the one used by the host system, in which case it is not necessary
to create another one.
Start a disk partitioning program such as cfdisk or fdisk with a command line option
naming the hard disk on which the new partition will be
the primary Integrated Drive Electronics (IDE) disk. Create a Linux
native partition and a
partition, if needed. Please refer to
if you do not yet know how to use the programs.
Remember the designation of the new partition (e.g.,
hda5). This book will refer to this as the LFS
partition. Also remember the designation of the
swap partition. These names will be needed later