The Hdparm package contains an utility that is useful for controlling ATA/IDE controllers and hard drives both to increase performance and sometimes to increase stability.
This package is known to build and work properly using an LFS-7.6 systemd platform.
As well as being useful, incorrect usage of Hdparm can destroy your information and in rare cases, drives. Use with caution and make sure you know what you are doing. If in doubt, it is recommended that you leave the default kernel parameters alone.
Download (HTTP): http://downloads.sourceforge.net/hdparm/hdparm-9.45.tar.gz
Download MD5 sum: 1c75d0751a44928b6c4bc81fb16d7fe8
Download size: 128 KB
Estimated disk space required: 1.1 MB
Estimated build time: less than 0.1 SBU
Build Hdparm by running the following command:
This package does not come with a test suite.
Now, as the
Note that by default, hdparm is installed in
/sbin as some systems may require
it during the boot process before
/usr is mounted. If you wish to install
hdparm under the
/usr hierarchy, then replace the
above command with the following:
make binprefix=/usr install
Last updated on 2014-10-04 11:05:47 +0000