The Fcron package contains a periodical command scheduler which aims at replacing Vixie Cron.
This package is known to build and work properly using an LFS-7.10 platform.
Download (HTTP): http://fcron.free.fr/archives/fcron-3.2.0.src.tar.gz
Download MD5 sum: 4b031c2fba32a98fa814d1557158b0e9
Download size: 584 KB
Estimated disk space required: 5.1 MB
Estimated build time: 0.1 SBU
User Notes: http://wiki.linuxfromscratch.org/blfs/wiki/fcron
Fcron uses the cron facility of syslog to log all messages. Since
LFS does not set up this facility in
/etc/syslog.conf, it needs to be done prior to
installing Fcron. This command
will append the necessary line to the current
/etc/syslog.conf (perform as the
cat >> /etc/syslog.conf << "EOF"
# Begin fcron addition to /etc/syslog.conf cron.* -/var/log/cron.log # End fcron additionEOF
The configuration file has been modified, so reloading the
sysklogd daemon will
activate the changes (again as the
For security reasons, an unprivileged user and group for
Fcron should be created (perform
groupadd -g 22 fcron && useradd -d /dev/null -c "Fcron User" -g fcron -s /bin/false -u 22 fcron
Install Fcron by running the following commands:
./configure --prefix=/usr \ --sysconfdir=/etc \ --localstatedir=/var \ --without-sendmail \ --with-boot-install=no \ --with-systemdsystemunitdir=no && make
This package does not come with a test suite.
Now, as the
DESTDIR install must be done as
default, Fcron will attempt to use
the sendmail command
from an MTA package to
email you the results of the fcron script. This switch is used
to disable default email notification. Omit the switch to enable
the default. Alternatively, you can use the
to use a different mailer command.
This prevents installation of the bootscript included with the
prevents building the systemd
units, which are not needed for a SYS
This switch allows you to set the default text editor.
May be used if you have DocBook-utils-0.6.14 installed.
Currently, the dsssl stylesheets are located at
There are no required changes in any of the config files.
Configuration information can be found in the man page for
fcron scripts are written using fcrontab. Refer to the fcrontab man page for proper parameters to address your situation.
If Linux-PAM is installed, two PAM
configuration files are installed in
/etc/pam.d. Alternatively if
/etc/pam.d is not used, the installation will
append two configuration sections to the existing
/etc/pam.conf file. You should ensure the files
match your preferences. Modify them as required to suit your
init script from the blfs-bootscripts-20160902 package.
Last updated on 2016-10-11 04:53:29 -0500